I tried closing everything and made sure nothing else was using the
emx-runtimes and still had the same problem.
Since you said 1.2 didn't need emxlibcm.dll I renamed it and then
re-ran my retrieve command (using both 1.1 and 1.2) and 1.1 failed
because emxlibcm.dll was missing, 1.2 failed as usual BUT the display
registers information pointed to VSOUP.EXE this time:
===========================================================
[D:\TEMP]d:\util2\vsoup11\vsoup -n -i pop3://holcombj:*******@pop.ral.mindspring.com
SYS1804: The system cannot find the file EMXLIBCM.
[D:\TEMP]d:\util2\vsoup12\vsoup -m -l 900 -a -i -N D:\yarn2\home\newsrc nntp://news.mindspring.com
WARNING: emx 0.9c or later required
Process terminated by SIGSEGV
core dumped
SYS1808:
The process has stopped. The software diagnostic
code (exception code) is 0005.
A program generated an access violation at 0001DBB2
VSOUP.EXE 0001:0000dbb2
I suspect I have "junk" left over from my Warp 3 installation.
-- ....................................................................... Jim Holcomb http://www.pobox.com/~jholcomb jim.holcomb@pobox.com Cary, NC, USA